Replacing The Cleaning Wiper - MUTOH ValueJet VJ-1638UR Operation Manual

[9] Attach the maintenance cover, and then close it.
[10]
CR Maint. :
CR Maint. :

Replacing the cleaning wiper

The cleaning wiper is an essential part to make printing consistent. Please replace it periodically.
Replacing period:
• Approx. every six months
Preparation
• Plastic gloves
• Rubber gloves
• Goggles
• Absorption material for the flushing box
• Paper you can get dirty (paper which ink will not bleed through)
CAUTION
Skin or eye contact with UV curable ink may cause skin inflammation or allergic reaction.
For this operation, be sure to wear the supplied gloves (or solvent resistant gloves) and goggles to prevent ink from contacting
with your eyes or skin.
Replacing Steps
[1] Put the printer into the CR maintenance mode.
"Putting the printer into the Daily maintenance mode" P. 117
[2]
128

Replacing the cleaning wiper

Press the [Enter] key.
End
The message on the left will appear.
Start
• That ends the procedure.
Open the maintenance cover on the right side.