MUTOH ValueJet VJ-1638UR Operation Manual page 65

PF2: Initial Change
PF2 : Initial Change
PF3: Confirm Print
PF3 : Confirm Print
• After the confirmation adjustment printing, cut the media.
• With a ruler, measure the length between "
orange dotted lines and arrows (the orange parts are not actually printed).
• If the measured length does not match the feeding length, re-correct with
• If the measured length matches the feeding length, proceed to
Note
The length of media that is fed (feeding length) for confirmation adjustment printing, is normally set at 250 mm.
If you increase the feeding length, the accuracy of the Media feed adjustment improves. To change the feeding length, press the [+] key or [ - ] key on
Operation panel and change the set value.
Use the [+] / [ - ] key to enter the adjustment value, and press the [Enter] key.
Setting values
Init. : 250.0 mm / 250 mm
Performs Confirm Print.
Enter the "Feed Length" and press the [Enter] key.
Setting values
Feed Length : 250 mm
" in the pattern. In the example below, the measured place is shown in
PF4: Micro
You can set a value that is between +50 mm
and -50 mm of the feed length configured in
"Initial Print".
100 mm to <250 mm> to 500 mm
<> indicates the initial value.
PF1: Initial Print.
Print.
Panel setup menu 65