MUTOH ValueJet VJ-1638UR Operation Manual page 66

PF4: Micro Print
PF4 : Micro Print
• Observe the pattern and verify the micro adjustment value. In the pattern, look for a place that has least white lines or
overlapping in images. The number printed below the pattern is the micro adjustment value.
Enter the micro adjustment value according to the print result.
Not Adequate
-0.10
+1.20 +0.80
Note
Once an appropriate micro adjustment value has been saved, the value will be the baseline value from the next time to be printed in the center of the pattern.
For example, if you have entered "-0.20" and print a micro adjustment pattern, values printed below block pattern will be changed to (from left) +1.00, +0.60,
+0.30, 0.00, -0.20 (baseline value), -0.30, -0.40, -0.70, -1.00, -1.40.
PF5: Micro Change
PF5 : Micro Change
66 Panel setup menu
Performs Micro adjustment Print.
Enter the appropriate micro adjustment value according to the print result.
Adequate Not Adequate
-0.20 -0.50
Micro Adjustment Value
+0.50 +0.20
Use the [+] / [ - ] key to enter the adjustment value, and press the [Enter] key.
Select whether you wish to perform confirmation print and complete the setup.
Setting values
Micro :
+0.10 0.00 -0.10
0.00%
-0.20 -0.50 -0.80
-5.00% to <0.00%> to 5.00%
<> indicates the initial value.
-1.20