Table of Contents
Advertisement
Print stop menu
Length :
Note
• Normally you can set this as "Off" as the rear sensor detects when the roll paper is finished.
• If you are using the roll media that does not come off the paper core easily when it is finished, printing may not be paused when the roll media is finished,
if the "Print stop menu" is set to "Off". If this happens, set this to "On".
Near End menu
Print Stop :
Set 11: FrontInterlace
Set 11:
FrontInterlace
76
Set 11: FrontInterlace
30 m
Enter
On
Enter
FrontInterlace :
Sets whether or not to display "Roll Remain Error" and pause printing when the length of
the roll media that is counted inside the printer becomes 0.
Setting values
Print Stop :
Off
Print Stop :
On
Sets whether or not to display "Roll Near End: *m" (* is replaced with a number between
1 and 10) before the length of the roll media that is counted inside the printer becomes 0.
Setting values
Near End :
Off
Near End :
Remain * m
This menu is used to set media edge treatment menu.
Setting values
Auto
The roll media remaining count is not used to
judge for pausing printing. Printing pauses
when the rear sensor responds.
This is the initially set value.
Even when the rear sensor does not respond,
printing pauses when the roll media remaining
count becomes 0.
"Near end" is not displayed.
This is the initially set value.
"Near end" is displayed when the remaining
count for the roll media becomes the length
you selected.
<Auto> / Off
<> indicates the initial value.
Advertisement
Table of Contents
Troubleshooting
