MUTOH ValueJet VJ-1638UR Operation Manual page 139

Display
[*******] Discharged
Full WasteInkTank
[******] S/C ReadErr
[******] S/C Col.Err
[*] S/C Ink Err
[*] S/C CodeErr
[*] Broken Chip
[*] Check Ink
Ready to Print/PFErr
Life Warning [CPump]
Replace [CPump]
Note
• [*******] in the error message indicates the target ink cartridge slot.
• If "Ink End" and "No Cartridge" occur at the same time, "No Cartridge" message has priority to be displayed.
Ink is not filled.
Perform initial ink charging.
"Performing initial charging after head cleaning" P. 132
The waste fluid tank has become full. (Stops operation)
Immediately transfer the waste fluid into a container.
"Emptying waste fluid tank" P. 106
Reading S/C Card has been failed.
Insert S/C Card again.
Ink cartridges (High capacity ink pack adapter) are inserted in wrong slots.
Insert ink cartridges (High capacity ink pack adapter) correctly again.
The ink cannot be used for this printer.
Contact your local MUTOH dealer.
Inserted ink cartridge (ink bag) is not a proper one.
Contact your local MUTOH dealer.
S/C Card has been broken.
Insert new ink cartridge (ink bag).
Ink cartridges (High capacity ink pack adapters) were not recognized
correctly.
Insert ink cartridges (High capacity ink pack adapters) correctly again.
Contact your local MUTOH dealer.
PF origin sensor could not detect the origin position for feeding.
You can still print, but print quality is not guaranteed.
If this still does not clear the problem, contact your local MUTOH dealer.
You must replace the Circulation pump.
Please contact your Mutoh dealer to replace the Circulation pump.
If you want to stop the beep and continue printing, follow these steps.
1. Press the [Enter] or [Cancel] key to stop the beep.
2. The message "MaintenanceCall?" appears on the operation panel. Use the
[+]/[-]key to select [Yes] or [No].
3. Press the [Enter] key.
• When [Yes] is selected, the message "Ready To Print" will appear on the
operation panel. You can continue printer operation.
• When [No] is selected, the message "Printer Stop Shortly" will appear on
the operation panel. Go to Step 4.
4. Press the [Enter] key. The message "Ready To Print" appears on the
operation panel.
The Circulation pump reached the end of the life cycle. You cannot operate
the printer from the operation panel until replacing the pump.
1. Press the [Enter] or [Cancel] key to stop the beep.
2. Contact your dealer immediately to replace the Circulation pump.
• In this stage, the automatic ink maintenance will no longer work. The
printer performance after the replacement cannot be guaranteed.
Description
Error message display and remedies 139