MUTOH ValueJet VJ-1638UR Operation Manual page 63

**>3: PF Adjust
* *> 3: PF Adjust >
Steps
1.
Select "PF1: Initial Print".
•
"Feed Length: 250 mm" is displayed on Operation panel.
2.
After the initial adjustment printing, cut the media.
•
Measure the distance between the "
3.
Refer to Chapter 1
4.
Press the [+] key or [ - ] key on Operation panel and enter the measured value in Step 2.
•
Press the [Enter] key to save the initial adjustment value.
5.
Press the [+] key or [ - ] key on Operation panel to select "PF3: Confirm Print".
•
"Feed Length: 250 mm" is displayed on Operation panel.
6.
After the confirmation adjustment printing, cut the media.
•
Measure the distance between the "
that the distance matches the feeding length when printing.
•
If the distance does not match the feeding length, follow the procedure from Step 1 to Step 5 and readjust.
•
If the distance matches the feeding length, proceed to Step 7.
Sets up various settings on the Media feed correction.
When the following defects are found in printing results, they may improve by
conducting a media feed correction.
• Images are overlapping.
• There are white lines in images.
Submenus
PF1 :
PF2 :
PF3 :
PF4 :
PF5 :
" in the initial adjustment print using a ruler.
"Media feed adjustment steps" P. 42
" in the confirmation adjustment print using a ruler. Then, confirm
Initial Print
Initial Change
Confirm Print
Micro Print
Micro Change
and select "PF2: Initial Change" on the operation panel.
"PF1: Initial Print" P. 64
"PF2: Initial Change" P. 65
"PF3: Confirm Print" P. 65
"PF4: Micro Print" P. 66
"PF5: Micro Change" P. 66
Panel setup menu 63