MUTOH ValueJet VJ-1638UR Operation Manual page 67

**>4: Vacuum Fan
* *> 4: Vacuum Fan
**>5: Thickness
* *> 5: Thickness
Note
• This menu is to automatically adjust print quality to a certain extent. If you want to improve print quality, manually adjust it.
"**>2: Adjust Print>" P. 59
• If you have adjusted the print settings, you do not need to configure the thickness of the media in this menu.
**>6: Media Initial
* *> 6: Media Initial
Note
When "**>6: Media Initial" is set to "Off", set the media width of the current media in "**>7: Media Width".
Sets up vacuum fan operation.
Use the [+] / [ - ] key to select the value, and press the [Enter] key.
• If you are using a thin or delicate media and there is risk of it wrinkling due to the fan,
set a lower value for the fan.
Setting values
Vacuum Fan : High
Sets the thickness of the media you are using.
Use the [+] / [ - ] key to enter the value, and press the [Enter] key.
Setting values
Thickness : 170 μm
Sets whether to detect the media width while initializing the media.
Setting values
Init. : Off
Init. : Top&Width
Init. : Width
<High> / Middle / Low / Off
<> indicates the initial value.
80 μm to <170 μm> to 2,800 μm
<> indicates the initial value.
The media will not be detected.
Detect the media width and edge while
initializing the media.
Detect the media width while initializing the
media.
This is the initially set value.
Panel setup menu 67