Offset Adjustment Procedure - MUTOH MC series Operation Instructions Manual

Preparing for a Job

OFFSET ADJUSTMENT PROCEDURE

In order to obtain perfect quality, MUTOH recommends you to perform
an offset adjustment routine each time you change cutting blades or
switch to another type of media.
To perform offset adjustment, you can select two offset modes, called BASE TUNE &
FINE TUNE.
• Base tune allows a limited adjustment, only setting the typical blade offset.
• Fine tune is a semi-automatic fine-tuning. In this mode, the plotter automatically
creates test patterns with different offsets allowing the user to choose the best result.
By factory default, the semi-automatic fine-tuning is activated.
Operation Instructions MC-Series cutting plotters
20
Page
AP-75020, Rev. 1.0 - 18/12/98