Drive Control Parameters - ABB ACS850 Firmware Manual

Drive control parameters

The Setting for fieldbus control column gives the value to use when the fieldbus
interface is the desired source or destination for that particular signal. The Function/
Information column gives a description of the parameter.
Parameter
10.01 Ext1 start func
10.04 Ext2 start func
21.01 Speed ref1
sel
21.02 Speed ref2
sel
24.01 Torq ref1 sel
24.02 Torq ref add
sel
16.07 Param save
Setting for
fieldbus control
CONTROL COMMAND SOURCE SELECTION
(3) FBA
(3) FBA
(3) FBA ref1
(4) FBA ref2
(3) FBA ref1
(4) FBA ref2
(3) FBA ref1
(4) FBA ref2
(3) FBA ref1
(4) FBA ref2
SYSTEM CONTROL INPUTS
(0) Done
(1) Save
Function/Information
Selects fieldbus as the source for the start
and stop commands when EXT1 is selected
as the active control location.
Selects fieldbus as the source for the start
and stop commands when EXT2 is selected
as the active control location.
Fieldbus reference REF1 or REF2 is used
as speed reference 1.
Fieldbus reference REF1 or REF2 is used
as speed reference 2.
Fieldbus reference REF1 or REF2 is used
as torque reference 1.
Fieldbus reference REF1 or REF2 is used
as torque reference addition.
Saves parameter value changes (including
those made through fieldbus control) to
permanent memory.
Fieldbus control 247