ABB ACS850 Firmware Manual page 81

No. Name/Value
D2D
In1F In2R
In1St In2Dir
10.05 Ext2 start in1
DI1
DI6
DIO4
Timed func
Const
Pointer
10.06 Ext2 start in2
DI2
DI5
DIO5
Const
Pointer
Description
The start and stop commands are taken from another drive
through the D2D (Drive-to-drive) Control Word.
The source selected by
start signal, the source selected by
reverse start signal.
State of source 1 State of source 2
(via par. 10.05) (via par. 10.06)
0 0
1 0
0 1
1 1
The source selected by
(0 = stop, 1 = start), the source selected by
in2 is the direction signal (0 = forward, 1 = reverse).
Selects source 1 of start and stop commands for external
control location EXT2. See parameter
selections In1 and 3-wire.
Note: This parameter cannot be changed while the drive is
running.
Digital input DI1 (as indicated by
Digital input DI1 (as indicated by
Digital input/output DIO4 (as indicated by
bit 3).
Bit 4 of parameter 06.14 Timed func
any one of the four timers configured in parameter group
Timed functions is on.
Bit pointer setting (see Terms and abbreviations
Selects source 2 of start and stop commands for external
control location EXT2. See parameter
selection 3-wire.
Note: This parameter cannot be changed while the drive is
running.
Digital input DI2 (as indicated by
Digital input DI5 (as indicated by
Digital input/output DIO5 (as indicated by
bit 4).
Bit pointer setting (see Terms and abbreviations
10.05 Ext2 start in1 is the forward
10.06 Ext2 start in2
Command
Stop
Start forward
Start reverse
Stop
10.05 Ext2 start in1 is the start signal
10.06 Ext2 start
10.04 Ext2 start
02.01 DI status, bit 0).
02.01 DI status, bit 5).
02.03 DIO
stat. The bit is on when
10.04 Ext2 start
02.01 DI status, bit 1).
02.01 DI status, bit 4).
02.03 DIO
Parameters 81
FbEq
4
5
is the
6
func,
1073742337
1074070017
status, 1073938947
1074005518
36
on page 63). -
func,
1073807873
1074004481
status, 1074004483
on page 63). -