ABB ACS850 Firmware Manual page 192

192 Parameters
No. Name/Value
FEN-11 ABS
FEN-11 TTL
FEN-21 RES
FEN-21 TTL
FEN-31 HTL
90.02 Encoder 2 sel
None
FEN-01 TTL+
FEN-01 TTL
FEN-11 ABS
FEN-11 TTL
FEN-21 RES
FEN-21 TTL
FEN-31 HTL
90.04 TTL echo sel
Disabled
FEN-01 TTL+
FEN-01 TTL
FEN-11 TTL
FEN-21 TTL
FEN-31 HTL
90.05 Enc cable fault
No
Fault
Description
Communication active. Module type: FEN-11 Absolute
Encoder Interface. Input: Absolute encoder input (X42).
Communication active. Module type: FEN-11 Absolute
Encoder Interface. Input: TTL encoder input (X41).
Communication active. Module type: FEN-21 Resolver
Interface. Input: Resolver input (X52).
Communication active. Module type: FEN-21 Resolver
Interface. Input: TTL encoder input (X51).
Communication active. Module type: FEN-31 HTL Encoder
Interface. Input: HTL encoder input (X82).
Activates the communication to the optional encoder/resolver
interface 2.
Note: The counting of shaft revolutions is not supported for
encoder 2.
Inactive.
See parameter 90.01 Encoder 1
See parameter 90.01 Encoder 1
See parameter 90.01 Encoder 1
See parameter 90.01 Encoder 1
See parameter 90.01 Encoder 1
See parameter 90.01 Encoder 1
See parameter 90.01 Encoder 1
Enables and selects the interface for the TTL encoder signal
echo.
Note: If encoder emulation and echo are enabled for the
same FEN-xx TTL output, the emulation overrides the echo.
Signal echo interface disabled.
Module type: FEN-01 TTL Encoder interface Module. Echo:
TTL encoder input (X32) pulses are echoed to the TTL
encoder output.
Module type: FEN-01 TTL Encoder interface Module. Echo:
TTL encoder input (X31) pulses are echoed to the TTL
encoder output.
Module type: FEN-11 Absolute Encoder Interface. Echo: TTL
encoder input (X41) pulses are echoed to the TTL encoder
output.
Module type: FEN-21 Resolver Interface. Echo: TTL encoder
input (X51) pulses are echoed to the TTL encoder output.
Module type: FEN-31 HTL Encoder Interface. Echo: TTL
encoder input (X51) pulses are echoed to the TTL encoder
output.
Selects the action in case an encoder cable fault is detected
by the FEN-xx encoder interface.
Cable fault detection inactive.
The drive trips on an ENCODER 1/2 CABLE fault.
sel.
sel.
sel.
sel.
sel.
sel.
sel.
FbEq
3
4
5
6
7
0
1
2
3
4
5
6
7
0
1
2
3
4
5
0
1