System - ABB ACS850 Firmware Manual

No. Name/Value
15.24 AO4 src min
-32768.000 ...
32768.000
15.25 AO ctrl word
Bit Name
0 AO1 func
1 AO2 func
16

16 System

16.01 Local lock
Const
Pointer
16.02 Parameter lock
Locked
Open
Not saved
16.03 Pass code
0 ... 2147483647
16.04 Param restore
Done
Restore defs
Clear all
Description
Defines the real value of the signal (selected by parameter
15.19 AO4 src) that corresponds to the minimum AO4 output
value (defined by parameter
parameter 15.23 AO4 src
Real signal value corresponding to minimum AO4 output
value.
Defines how a signed source is processed before output.
Information
1 = AO1 is bipolar
0 = AO1 is absolute value of source
1 = AO2 is bipolar
0 = AO2 is absolute value of source
Parameter lock, parameter restore, user parameter sets etc.
Selects the source for disabling local control (Take/Release
button in the PC tool, LOC/REM key of the panel).
0 = Local control enabled.
1 = Local control disabled.
WARNING! Before activating, ensure that the
control panel is not needed for stopping the drive!
Bit pointer setting (see Terms and abbreviations
Selects the state of the parameter lock. The lock prevents
parameter changing.
Locked. Parameter values cannot be changed from the
control panel. The lock can be opened by entering the valid
code into parameter 16.03 Pass
The lock is open. Parameter values can be changed.
The lock is open. Parameter values can be changed, but the
changes will not be stored at power switch-off.
Selects the pass code for the parameter lock (see parameter
16.02 Parameter lock).
After entering 358 at this parameter, parameter
Parameter lock can be adjusted. The value reverts back to 0
automatically.
Pass code for parameter lock.
Restores the original settings of the application, i.e.
parameter factory default values.
Note: This parameter cannot be changed while the drive is
running.
Restoring is completed.
All parameter values are restored to default values, except
motor data, ID run results, and fieldbus, drive-to-drive link and
encoder configuration data.
All parameter values are restored to default values, including
motor data, ID run results and fieldbus and encoder
configuration data. PC tool communication is interrupted
during the restoring. Drive CPU is re-booted after the
restoring is completed.
15.22 AO4 out min). See
max.
on page 63). -
code.
16.02
Parameters 115
FbEq
1000 = 1
0
1
2
1 = 1
0
1
2