ABB ACS850 Firmware Manual page 174

174 Parameters
No. Name/Value
44.05 Ontime2 func
Bit Function
0 Counter mode
0 = Loop: If alarm is enabled by bit 1, the alarm stays active only for 10 seconds.
1 = Saturate: If alarm is enabled by bit 1, the alarm stays active until reset.
1 Alarm ena (Alarm enable)
0 = Disable: No alarm is given when limit is reached.
1 = Enable: Alarm is given when limit is reached.
44.06 Ontime2 src
RO1
Running
Charged
Const
Pointer
44.07 Ontime2 limit
0 ... 2147483647 s
44.08 Ontime2 alm sel
On-time2
Device clean
Add cool fan
Cabinet fan
Dc-capacitor
Mot bearing
Description
Configures on-time counter 2. This counter runs whenever
the signal selected by parameter
After the limit set by parameter
reached, an alarm specified by parameter
sel is given, and the counter reset.
The current value of the counter is readable from parameter
04.10 Counter ontime2. Bit 1 of
indicates that the count has exceeded the limit.
Selects the signal to be monitored by on-time counter 2. See
parameter 44.05 Ontime2
Relay output RO1 (as indicated by
Bit 3 of 06.01 Status word1
Bit 9 of 06.02 Status word2
Bit pointer setting (see Terms and abbreviations
Sets the alarm limit for on-time counter 2. See parameter
44.05 Ontime2 func.
Alarm limit for on-time counter 2.
Selects the alarm for on-time counter 2. See parameter
Ontime2 func.
Pre-selectable alarm for on-time counter 2.
Pre-selectable alarm for on-time counter 2.
Pre-selectable alarm for on-time counter 2.
Pre-selectable alarm for on-time counter 2.
Pre-selectable alarm for on-time counter 2.
Pre-selectable alarm for on-time counter 2.
44.06 Ontime2 src
44.07 Ontime2 limit
44.08 Ontime2 alm
06.15 Counter status
func.
02.02 RO status, bit 0).
(see page 73).
(see page 74).
on page 63). -
FbEq
is on.
is
1073742338
1073939969
1074333186
1 = 1 s
44.05
0
1
2
3
4
5