ABB ACS850 Firmware Manual page 116

116 Parameters
No. Name/Value
16.07 Param save
Done
Save
16.09 User set sel
No request
Load set 1
Load set 2
Load set 3
Load set 4
Save set 1
Save set 2
Save set 3
Save set 4
IO mode
16.10 User set log
N/A
Loading
Saving
Faulted
Set1 IO act
Set2 IO act
Set3 IO act
Set4 IO act
Set1 par act
Set2 par act
Set3 par act
Set4 par act
Description
Saves the valid parameter values to the permanent memory.
Note: A new parameter value is saved automatically when
changed from the PC tool or panel but not when altered
through a fieldbus connection.
Save completed.
Save in progress.
Enables the saving and restoring of up to four custom sets of
parameter settings.
The set that was in use before powering down the drive is in
use after the next power-up.
Note: Any parameter changes made after loading a set are
not automatically stored – they must be saved using this
parameter.
Load or save operation complete; normal operation.
Load user parameter set 1.
Load user parameter set 2.
Load user parameter set 3.
Load user parameter set 4.
Save user parameter set 1.
Save user parameter set 2.
Save user parameter set 3.
Save user parameter set 4.
Load user parameter set using parameters
lo and 16.12 User IO sel
Shows the status of the user parameter sets (see parameter
16.09 User set sel). Read-only.
No user sets have been saved.
A user set is being loaded.
A user set is being saved.
Invalid or empty parameter set.
User parameter set 1 has been selected by parameters
User IO sel lo and 16.12 User IO sel
User parameter set 2 has been selected by parameters
User IO sel lo and 16.12 User IO sel
User parameter set 3 has been selected by parameters
User IO sel lo and 16.12 User IO sel
User parameter set 4 has been selected by parameters
User IO sel lo and 16.12 User IO sel
User parameter set 1 has been loaded using parameter
User set sel.
User parameter set 2 has been loaded using parameter
User set sel.
User parameter set 3 has been loaded using parameter
User set sel.
User parameter set 4 has been loaded using parameter
User set sel.
16.11 User IO sel
hi.
hi.
hi.
hi.
hi.
FbEq
0
1
1
2
3
4
5
6
7
8
9
10
0
1
2
4
16.11 8
16.11 16
16.11 32
16.11 64
16.09 128
16.09 256
16.09 512
16.09 1024