ABB ACS850 Firmware Manual page 70

70 Parameters
No. Name/Value
Bit Name
(continued)
9 Limit
10 Above limit
11 Ext2 act
12 Local fb
13 Zero speed
14 Rev act
15 Reserved
16 Fault
17 Local panel
18...26 Reserved
27 Request ctl
28 CW B28
29 CW B29
30 CW B30
31 CW B31
02.26 FBA main ref1
02.27 FBA main ref2
02.30 D2D main cw
Bit Information
0 Stop.
1 Start.
2 ... 6 Reserved.
7 Run enable. By default, not connected in a follower drive.
8 Reset. By default, not connected in a follower drive.
9 ... 14 Freely assignable through bit pointer settings.
15 EXT1/EXT2 selection. 0 = EXT1 active, 1 = EXT2 active. By default, not connected in a
follower drive.
Description
Value Information
1 Operation is limited by any of the torque limits.
0 Operation is within the torque limits.
1 Actual speed exceeds limit defined by parameter
lim.
0 Actual speed is within the defined limits.
1 External control location EXT2 is active.
0 External control location EXT1 is active.
1 Fieldbus local control is active.
0 Fieldbus local control is inactive.
1 Drive speed is below limit defined by parameter
limit.
0 Drive has not reached zero speed limit.
1 Drive is running in reverse direction.
0 Drive is running in forward direction.
1 A fault is active. See chapter
0 No fault is active.
1 Local control is active, i.e. the drive is controlled from PC tool or
control panel.
0 Local control is inactive.
1 Control Word is requested from fieldbus.
0 Control Word is not requested from fieldbus.
Programmable control bits (unless fixed by the used profile). See parameters
50.08...50.11 and the user manual of the fieldbus adapter.
Scaled fieldbus reference 1. See parameter
modesel.
Scaled fieldbus reference 2. See parameter
modesel.
Drive-to-drive control word received from the master. See
also actual signal 02.31 D2D follower
19.08 Above speed
19.06 Zero speed
Fault tracing.
50.04 Fba ref1
50.05 Fba ref2
cw.
FbEq
1 = 1
1 = 1
-