Basic Start/Stop Operation; Start/Stop Control; Start/Stop Interlocking - ABB ACL30 User Manual

132 Program features

Basic start/stop operation

The basic start/stop functions can be used for the elevator start/stop control and the
interlocks related to basic operation.


Start/stop control

Start/stop control comprises the logic and commands for starting the elevator in
upward and downward directions. Starting method can be selected with parameter
10.01 START FUNC. There are two basic methods:
• IN1 F IN2R – this selection defines separate start signals for upward and
downward directions. The source selected with
up (upward) signal and the source selected with
start down (downward) signal.
• IN1S IN2DIR – this selection defines one signal for start and another signal for the
direction of the elevator. The source selected with
start signal and the source selected with
(0 = up, 1 = down).
Start/stop control operates in the normal travel mode, releveling mode and
evacuation mode. The inspection mode has a start/stop control of its own. For more
information, see section
Settings
Parameters
10.01 START FUNC
10.02 UP COMMAND
10.03 DOWN COMMAND


Start/stop interlocking

The start/stop interlocking function stops or blocks the start command using
parameter 10.80 LIFT RUN ENABLE without generating any fault or warning in the
drive. When the signal configured with parameter
not start, or if the drive is running, it will stop.
Settings
Parameters
10.80 LIFT RUN ENABLE
Inspection mode on page 135.
Additional information
Selects the source for the start and stop control in external control.
Selects the source 1 for the start and stop commands in external control.
Selects the source 2 for the start and stop commands in external control.
Additional information
Selects the source for the Run enable signal.
10.02 UP COMMAND is the start
10.03 DOWN COMMAND is the
10.02 UP COMMAND is the
10.03 DOWN COMMAND is the direction
10.80 is switched Off, the drive will