Cursor:auto:item - Rigol DS1000Z Series Programming Manual

Chapter 2 Command System

:CURSor:AUTO:ITEM

Syntax
:COUSor:AUTO:ITEM <item>
:CURSor:AUTO:ITEM?
Description
The auto cursor function can measure 24 waveform parameters. Using this command,
you can select the parameters to be measured by the auto cursor from the five
parameters enabled last or query the parameters currently measured by the auto cursor.
Parameter
Name
<item>
Explanation


Return The query returns OFF, ITEM1, ITEM2, ITEM3, ITEM4 or ITEM5.
Format
Example :COUSor:AUTO:ITEM ITEM3
Related
:CURSor:MODE
Commands
:MEASure:ITEM
DS1000Z Programming Guide
Type
Discrete
You can select the auto cursor measurement mode using the
command.
The 24 waveform parameters are listed below (see the detailed introduction
in :MEASure Commands). The parameters can be enabled by the
command.
Period, Frequency, Rise Time, Fall Time, + Width, -Width, +Duty, -Duty, Delay
1→2 , Delay 1→2 , Phase 1→2 , Phase 1→2 , Vmax, Vmin, Vpp, Vtop, Vbase,
Vamp, Vavg, Vrms, Overshoot, Preshoot, Area, Period Area.
Range
{OFF|ITEM1|ITEM2|ITEM3|ITEM4|ITEM5}
RIGOL
Default
OFF
:CURSor:MODE
:MEASure:ITEM
2-25