Rigol DS1000Z Series Programming Manual page 66

RIGOL
Wherein,
Phase
"Delay 1→2 " and
Voltage Parameters

Vmax:
the voltage value from the highest point of the waveform to the GND.
Vmin:
the voltage value from the lowest point of the waveform to the GND.
Vpp:
the voltage value from the highest point to the lowest point of the waveform.
Vtop:
the voltage value from the flat top of the waveform to the GND.
Vbase: the voltage value from the flat base of the waveform to the GND.
Vamp: the voltage value from the top of the waveform to the base of the waveform.
Vavg: the arithmetic average value on the whole waveform or on the gating area.
Average
points being measured.
Vrms: the root mean square value on the whole waveform or the gating area.
RMS
points being measured.
Overshoot:
the ratio of the difference between the maximum value and top value of the waveform
to the amplitude value.
Preshoot:
the ratio of the difference between the minimum value and base value of the waveform
to the amplitude value.
Vmax
Vmin
2-52
denotes "Phase 1→2 " or "Phase 1→2 ",
denotes the period of source 1.
Period 1
Source 1
Source 2
∑
x
=
, wherein,
i
n
n
∑
2
x
i
=
= , where,
i 1
n
Overshoot
Vtop
Vamp
Vpp
Vbase
Preshoot
Delay
Period
Delay
is the point being measured,
ith
x
i
is the point being measured,
ith
x
i
Chapter 2 Command System
denotes "Delay 1→2 " or
is the number of
n
is the number of
n
DS1000Z Programming Guide