Trigger:pattern - Rigol DS1000Z Series Programming Manual

Chapter 2 Command System

:TRIGger:PATTern

Command List:
:TRIGger:PATTern:PATTern

:TRIGger:PATTern:LEVel

:TRIGger:PATTern:PATTern
Syntax :TRIGger:PATTern:PATTern <pattern1>,<pattern2>,<pattern3>,<pattern4>
:TRIGger:PATTern:PATTern?
Description Set or query the pattern of each channel in pattern trigger.
Parameter Name
<pattern1>
<pattern2>
<pattern3>
<pattern4>
Explanation

than the threshold level of the channel.

than the threshold level of the channel.

used as a part of the pattern. When all the four channels in the pattern are set to
"Don't Care", the oscilloscope will not trigger.


at the same time. If one edge item is currently defined and then another edge item is
defined in another channel in the pattern, the former edge item defined will be
replaced by X.

CH3 and CH4 respectively.
Return
The query returns the patterns of all the channels.
Format
Example
:TRIGger:PATTern:PATTern H,R,L,X
DS1000Z Programming Guide
Type
Discrete
Discrete
Discrete
Discrete
H: set the pattern of the channel selected to "H", namely the voltage level is higher
L: set the pattern of the channel selected to "L", namely the voltage level is lower
X: set the pattern of the channel selected to "Don't Care", namely this channel is not
R/F: set the pattern to the rising or falling edge of the channel selected.
You can not to specify the patterns of two channels to the rising edge or falling edge
The four parameters from left to right in the command set the patterns of CH1, CH2,
Range
{H|L|X|R|F}
{H|L|X|R|F}
{H|L|X|R|F}
{H|L|X|R|F}
RIGOL
Default
X
X
X
X
2-99