Reading Out Parameters Of The Ethernet/Ip Module - Mitsubishi Electric MELSEC Q Series User Manual

7
UTILITY PACKAGE (SW1DNC-EIPUTL-E)
7.10.3
(1) Displaying the "Upload Parameter" window
(2) "Upload Parameter" window and setting description
Item
PLC Type
PC I/F
Nic No.1 to 4 Start I/O
No.
7
- 59 7.10 Online

7.10.3 Reading out parameters of the EtherNet/IP module

Reading out parameters of the EtherNet/IP module
Reads out the parameters of the EtherNet/IP module.
Click [Online] [Upload Parameter].
"Transfer Setup" window will be displayed if the above operation is performed without
setting the connected EtherNet/IP module.
Refer to the following and complete the setting.
Section 7.10.1 Configuring the EtherNet/IP module
Figure 7.34 "Upload Parameter" window
Table 7.28 Description of the "Upload Parameter" window
Displays the QCPU set on the "Transfer Setup" window.
Displays the connection interface set on the "PC side I/F Setting" window.
Displays the start I/O No. of the EtherNet/IP module at connection destination.
Description
Reference
section
Section 7.10.1
(2)
Section 7.10.1
(2)
Section 7.9.1
(1)