UTILITY PACKAGE (SW1DNC-EIPUTL-E)
7.9 "Setting" Tab (Parameter Settings)
7.9.2 "Producer" window
Table 7.17 "Producer Tag" window settings (Continued)
The refresh device can be set with "Device" when the checkbox is selected.
When auto refresh settings are made in the "Refresh Parameter" window, the settings made here are disabled.
When using the auto refresh function, set the refresh target device and the start number of the device.
When "Refresh Device" is set in the "Refresh Parameter" window, settings for the refresh target device cannot
be made in the this window. (
To set the refresh target device for each Tag in this window, delete the "Refresh Device" settings in the
"Refresh Parameter" window.
0 to 32752
0 to 61424
Set the auto refresh target device.
0 to 4212735
The settings can be made in the range of "Device" in "Q Parameter Setting" of GX Works2.
0 to 32767
Note that other modules and EtherNet/IP modules having a different Nic No. must not use the
same auto refresh target devices.
0 to EFF0
When using a bit device, make settings in 16-point units (such as M16).
0 to 4047FF
0 to 4184063
A reserved Tag can be configured when the checkbox is selected. (
A reserved Tag just reserves Data Area and does not communicate actually.
* 1 To use a tag name with 41 or more characters, the setting in "Add Own Nic" window is required.
Section 7.9.1 (1) Display and settings of the "Add Own Nic" window)
Section 7.9.7 "Refresh Parameter" window)
Section 4.2.1 (4) Reserved tag)