Mitsubishi Electric MELSEC Q Series User Manual page 233

9
TROUBLESHOOTING
(5) Own station error of the EtherNet/IP module
Error code
Error
(Hex.)
Tag communication
start request (Y00)
C300
H
execution condition
error
PING test execution
C301
H
error
Connection
Monitoring
C303
H
execution condition
error
Flash ROM access
request (Y06)
C304
H
execution condition
error
TCP/UDP/IP
parameter change
C305 request (Y08)
H
execution condition
error
C306 Battery error
H
C307 to
H
System error
C308
H
(6) Errors of PING test (Error)
Error code
Error
(Hex.)
IP Address setting
C400
H
error
Table 9.7 Own station error of the EtherNet/IP module
Error detail
An error was detected in the execution conditions
for turning on the Tag communication start
request (Y00).
An error was detected in the execution conditions
for the PING test execution.
An error was detected in the execution conditions
for displaying the "Connection" window on the
"Monitoring" tab in Utility Package.
An error was detected in the execution conditions
for turning on the Flash ROM access request
(Y06).
An error was detected in the execution conditions
for turning on the TCP/UDP/IP parameter change
request (Y08).
Battery voltage drop or battery connector
disconnection has occurred.
System error
Table 9.8 PING test error (Error)
Error detail
•IP address is invalid.
•The IP address of the own station was specified
for the PING test.
Action
Turn off the following signals before turning on the
Tag communication start request (Y00).
•PING test execution request (Y02)
•Flash ROM access request (Y06)
•TCP/UDP/IP parameter change request (Y08)
•Acquiring IP address (X0D)
Turn off the following signals before the PING test
execution.
•Tag communication start request (Y00)
•Flash ROM access request (Y06)
•TCP/UDP/IP parameter change request (Y08)
•Acquiring IP address (X0D)
Turn off the following signals before displaying the
"Connection" window in Utility Package.
•PING test execution request (Y02)
•Flash ROM access request (Y06)
•TCP/UDP/IP parameter change request (Y08)
Turn off the following signals before turning on the
Flash ROM access request (Y06).
•Tag communication start request (Y00)
•PING test execution request (Y02)
•TCP/UDP/IP parameter change request (Y08)
Turn off the following signals before turning on the
TCP/UDP/IP parameter change request (Y08).
•Tag communication start request (Y00)
•PING test execution request (Y02)
•Flash ROM access request (Y06)
•Replace the battery.
•Check the battery connection status.
Please consult your local Mitsubishi
representative.
Action
Correct the IP address setting.
9.4 Error Code
9.4.2 Error code list
9
9
- 20