Mitsubishi Electric MELSEC Q Series User Manual page 185

7
UTILITY PACKAGE (SW1DNC-EIPUTL-E)
(3) Precautions
(a) Perform either of the operation below when writing intelligent function module
(b) For multiple CPU systems, write parameters only to the control CPU of the
(c) Set the total size of the character string information parameters (Nic Name, Node
parameters other than those of the EtherNet/IP module to a QCPU through GX
Works2.
• After writing auto refresh parameters in Utility Package, read the intelligent
function module parameters by "Read form PLC" of GX Works2.
Figure 7.33 "Read from PLC" window of GX Works2
• After writing intelligent function module parameters other than those of the
EtherNet/IP module, write auto refresh parameters of the EtherNet/IP module
by Utility Package.
The auto refresh parameters set to the EtherNet/IP module will be cleared if the
intelligent function module parameters other than those of the EtherNet/IP module
are written to a QCPU without above operation.
EtherNet/IP module.
Name, Tag name, Data Type name, define name) as below.
• 32K words or less for one module (Own Nic)
• 128K words or less for one project
Data cannot be written into the module if the total exceeds the sizes above.
For details on the calculation for the total size of the character string information
parameters, refer to the following.
Appendix 4 Calculation for the Total Size of Character String Information
Parameters
7.10.2 Writing parameters to the EtherNet/IP module
7
7.10 Online
- 58
1
2
3
4
5
6
7
8