How To Change To Ethernet Module Connection; Controller Setting Of The Got - Mitsubishi Electric RD81RC96-CA Manual

7.7 How to Change to Ethernet Module Connection

The setting example is as below.
■System configuration
GOT2000
・ GT27**-V(640×480)
・ Interface:
Standard I/F(Ethernet)
Ethernet cable *1
*1: For details on the cable, please refer to the manual below.
⇒"GOT2000 Series Connection Manual (Mitsubishi Electric Products)"
*2: The maximum number of network cameras can be connected to one camera recorder module is 4.
For details, please refer to "MELSEC iQ-R System Recorder User's Manual (Startup)".
For the network cameras can be connected, please refer to "Applicable Products for Camera Recorder
Module" (FA-A-0326).

Controller Setting of the GOT

■Controller Setting
Item
Manufacturer
Controller Type
I/F
■CH1 Detail Setting
GOT NET No.
GOT Station
GOT Communication Port No.
Retry (Times)
Startup Time (Sec)
Timeout Time (Sec)
Delay Time (ms)
CPU No. switching GD device first No. (3 points)
Module No. switching GD device first No. (16 points)
Servo axis switching GD device first No. (16 points)
■CH1 Connected Ethernet Controller Setting
Host Net No.
1 *
R base module
RCPU
Hub
Set Value
MITSUBISHI ELECTRIC
MELSEC iQ-R,RnMT/NC/RT,CR800-D
Ethernet: Multi
Item
Station Unit Type
1 1 RJ71EN71
Ethernet
RD81RC96-CA
module
Set Value
1
18
5001
3
3
3
0
500
550
10
IP Address
192.168.3.40
53/59
GT27/25
RD81RC96-CA
Network
camera *2
Remarks
Remarks
Port No. Communication
5001
UDP
BCN-P5999-1333-2a
SoftGOT