Mitsubishi Electric MELSEC Q Series User Manual page 224

9
TROUBLESHOOTING
Error code
Error
(Hex.)
Tag Parameter
C011
H
error
TCP/UDP/IP and
C012 Tag Parameter
H
error
C013 System error
H
C014 to Tag Parameter
H
C019 error
H
Flash ROM
C01A
H
initialization error
Tag Parameter
C01B
H
error
Extension Common
Parameter error
C01C (Extension
H
Input/Output Area
Size setting error)
Flash ROM writing
C020
H
error
Tag Parameter
C021
H
error
9
- 11 9.4 Error Code
9.4.2 Error code list
Table 9.5 Parameter error of the EtherNet/IP module (Error) (Continued)
Error detail
Tag Parameter data is invalid
Both any of TCP/UDP/IP parameters and Tag
Parameter data are invalid.
System error
Tag Parameter may be corrupt.
Writing to the Flash ROM or initialization of the
Flash ROM has failed.
Tag Parameter may be corrupt.
The total size set in the following areas is over
4,000 (16384).
H
•Class1 Extension Input Area Size(Un\G16630)
•Class3/UCMM Extension Input Area
Size(Un\G16631)
•Class1 Extension Output Area Size(Un\G16632)
Failed to write parameters to the flash ROM.
Tag Parameter may be corrupt.
Action
Check the error details by any of the following and
correct the Tag Parameter.
•"Detail View" window on the "Main" tab in Utility
Package
•Class1 Diagnostics Information (Un\G27392 to
Un\G27647)
•Class3/UCMM Diagnostics Information
(Un\G27648 to Un\G27903)
Same actions as for error codes C010
C011
H.
Please consult your local Mitsubishi
representative.
Write the parameters in Utility Package again.
Write data into the Flash ROM or initialize the
Flash ROM again.
If the same error code appears again, please
consult your local Mitsubishi representative.
Write the parameters in Utility Package again.
•Correct the total size set in the following areas to
4,000 (16384) or less.
H
•Class1 Extension Input Area Size(Un\G16630)
•Class3/UCMM Extension Input Area
Size(Un\G16631)
•Class1 Extension Output Area Size(Un\G16632)
•Write the parameters in Utility Package again.
•If the same error code appears again, please
consult your local Mitsubishi representative.
Write the parameters in Utility Package again.
and
H