Setting Ethernet/Ip Communications (Starting Ethernet/Ip Configuration Tool For Fx5-Enet/Ip); Writing Parameters - Mitsubishi Electric MELSEC iQ-F Series User Manual

7.5
Setting EtherNet/IP Communications (Starting
EtherNet/IP Configuration Tool for FX5-ENET/IP)
Start EtherNet/IP Configuration Tool for FX5-ENET/IP, and then set EtherNet/IP communications.
For details, refer to the following.
Page 55 EtherNet/IP Configuration Tool for FX5-ENET/IP
• Even if the GX Works3 is closed while EtherNet/IP Configuration Tool for FX5-ENET/IP is starting, it can
operate independently. Configuration tool operations can continue.
• While EtherNet/IP Configuration Tool for FX5-ENET/IP is running, another EtherNet/IP Configuration Tool
for FX5-ENET/IP cannot be started.
7.6

Writing Parameters

The parameters set on the FX5-ENET/IP have different write destinations.
Parameter type
Module parameter
EtherNet/IP communication setting
For writing parameters to the CPU module, refer to the following.
GX Works3 Operating Manual
This section describes writing procedure to the FX5-ENET/IP.
Operating procedure
1.
Switch EtherNet/IP Configuration Tool for FX5-ENET/IP to the online state.
[File]  [Go Online]
2.
Write the set parameters to the FX5-ENET/IP.
[File]  [Download]
The parameters written to the FX5-ENET/IP with EtherNet/IP Configuration Tool for FX5-ENET/IP are
reflected when the following operations are executed.
• The power supply of FX5-ENET/IP (CPU module) is turned off and on.
7 PARAMETER SETTINGS
54

7.5 Setting EtherNet/IP Communications (Starting EtherNet/IP Configuration Tool for FX5-ENET/IP)

Configuration tool
GX Works3
EtherNet/IP Configuration Tool for FX5-ENET/IP
Write destination
CPU module
FX5-ENET/IP