Download  Print this page

Tag Communication Start Request (y00), Tag Communication Start Process Completion (x00) - Mitsubishi Electric MELSEC Q Series User Manual

Ethernet/ip network interface module for programmable controller.
Hide thumbs

Advertisement

3
SPECIFICATIONS
3.2.2
These signals are used to start and stop a Tag communication.
The start timing of Tag communication after the Tag communication start request (Y00) is
turned on varies by tag type.
Table 3.4 Start timing of Tag communication after the Tag communication start request (Y00) is turned on.
Class1 Tag communication
Class3 Tag communication
UCMM Tag communication
For details of Tag communications, refer to the following.
(1) Operation
3
- 4
3.2 I/O Signals for the QCPU

3.2.2 Tag communication start request (Y00), Tag communication start process completion (X00)

Tag communication start request (Y00), Tag communication start
process completion (X00)
Tag type
Producer Tag
Consumer Tag
Target
Originator
Target
Originator
Section 4.2 Tag Communication Function
(a) Write parameters to the EtherNet/IP module using Utility Package.
(b) Confirm that all of the following signals are off before turning on the Tag
communication start request (Y00).
• PING test execution request (Y02)
• Flash ROM access request (Y06)
• TCP/UDP/IP parameter change request (Y08)
• Acquiring IP address (X0D)
(c) When Tag communication is started normally, the start addresses of send/receive
data and the status of reserved tags are stored in the following areas, and the Tag
communication start process completion (X00) is turned on.
• Class1 send/receive data start address (Un\G25856 to Un\G26367)
• Class3/UCMM send/receive data start address (Un\G26368 to Un\G26879)
• Reserved tag (Class1)(Un\G27168 to Un\G27183)
• Reserved tag (Class3/UCMM)(Un\G27216 to Un\G27231)
Upon completion of storing data in the above areas, Tag communication is
started.
The status and data of the Tag communication are stored in the following areas.
• Communication Status (Class1)(Un\G27136 to Un\G27151)
• Communication Status (Class3/UCMM)(Un\G27184 to Un\G27199)
• Input Area (Un\G0 to Un\G8191)
• Output Area (Un\G8192 to Un\G16383)
Tag communication start timing
Tag communication is executed when a request from the
corresponding device is received.
Tag communication starts upon completion of the processing
for Tag communication start of the EtherNet/IP module.
Tag communication is executed when a request from the
corresponding device is received.
Tag communication starts upon completion of the processing
for Tag communication start of the EtherNet/IP module.
Tag communication is executed when a request from the
corresponding device is received.
Tag communication starts when an Application Trigger
request (Class3/UCMM) is turned on.

Advertisement

Table of Contents

   Related Manuals for Mitsubishi Electric MELSEC Q Series

This manual is also suitable for:

Qj71eip71

Comments to this Manuals

Symbols: 0
Latest comments: