Ftp Server Support Functions Of The Ethernet Module - Mitsubishi Electric Melsec Q Series User Manual

5 WHEN USING FILE TRANSFER FUNCTIONS (FTP SERVER)

5.1.1 FTP server support functions of the Ethernet module

The FTP commands supported by Ethernet module when it serves as the FTP server
are indicated below:
The "Write enable setting" and "Write disable setting" columns in the table indicate the
settings in the "Ethernet Operation Setting" screen of a programming tool (checking the
checkbox next to "Enable Online Change").
("Write enable setting": check the checkbox, "Write disable setting": do not check the
checkbox.)
The "Remote password" indicates whether the instruction can be executed when the
FTP communication port is designated as a port subject to the remote password check
in the remote password setting (parameter) for the Q/LCPU of the station where the
Ethernet module is connected.
See the User's Manual (Basic) for the remote password.
(1) Client-side user interface command list (supported by Ethernet
Command Function
binary
Notify to transfer without converting file
3
( )
bye Disconnect and end the connection with FTP server
close Disconnect the line with FTP server
delete Delete the file of a CPU module
dir Display the file information of a CPU module
get Read a file from a CPU module
Is Display the file name of a CPU module
mdelete Delete the file of a CPU module
Store the file information of a CPU module into the
mdir
displayed file
mget Read a file from a CPU module
mls Store the file name of a CPU module into a file
mput Write a file to a CPU module
open Connect with FTP server
put Write a file to a CPU module
pwd Display the current directory of a CPU module
quit Disconnect and end the connection with FTP server
quote Send FTP server sub-command
5 - 2
module)
Programmable controller CPU status
During
STOP
1 The parameter file and the sequence program file cannot be deleted when a CPU
module is in RUN.
2 The list of Ethernet module dedicated commands used along with the quote
command is described.
When executing the commands from the FTP client, attach the command after the
"quote" command.
(Example) When executing the stop command.
Enter the following in the command prompt.
quote stop <ret>
3 This setting is automatically set to an Ethernet module.
Files are transferred in binary regardless of the setting in the "Communication
Data Code" field on the "Ethernet Operation Setting" screen of a programming
tool.
Remote password
During RUN
While
Write enable Write disable
unlocked
setting setting
1
( )
1
( )
MELSEC-Q/L
Remarks
While locked
—
Can only use Ethernet
module dedicated
2
commands ( )
5 - 2
5