Mitsubishi Electric MELSEC Q Series User Manual page 182

7
UTILITY PACKAGE (SW1DNC-EIPUTL-E)
Item
PLC Type
PC I/F
Nic No.1 to 4
Start I/O No.
button
Connection Test
(3) Precautions
7
- 55 7.10 Online
7.10.1 Configuring the EtherNet/IP module
Table 7.26 Description of the "Transfer Setup" window
Select the model name of the QCPU.
Clicking the
PC I/F Setup
Select the connection interface type.
The following settings must be made when "RS-232C" or "Ethernet (Connection
via hub)" is selected.
<When selecting RS-232C>
<When selecting Ethernet (Connection via hub)>
Item
COM Port
Transmission Speed
Protocol
CPU IP Address
Set the start I/O No. of the EtherNet/IP module. (Hex.)
When there is an Own Nic, the start I/O No. that has been set in the "Add Own
Nic" window of the "Basic" window is displayed.
Run a test to see if a connection can be made with the CPU module
The Built-in Ethernet port QCPU is the only CPU that can be used for an Ethernet
connection. Connections cannot be made via Ethernet interface module or other
modules.
Description
button will display the "PC side I/F Setting" window.
Description
Select the COM port.
This item is selectable only when "RS-232C" is
selected.
Select the transmission speed.
This item is selectable only when "RS-232C" is
selected.
Select the protocol of the Built-in Ethernet port
QCPU from "TCP" or "UDP".
Enter the IP address of the Built-in Ethernet port
QCPU.
Reference
section
-
-
Section 7.9.1
(1)
-