Battery; Battery Specifications; Installing The Battery - Mitsubishi Electric MELSEC Q Series User Manual

5
PRE-OPERATION PROCEDURES
5.4

Battery

This section describes installation and replacement of the battery.
5.4.1
The specifications of the battery for the EtherNet/IP module are shown below.
Type
Initial voltage
Nominal current
Battery life when not used
Battery life when used
Lithium content
Application
Remark
5.4.2
Battery connector of the EtherNet/IP module battery is disconnected for shipping.
Connect the battery connector before using.
Open the cover on the EtherNet/IP
module bottom.
Check that the battery has been
installed correctly.
Engage the battery connector with
the connector pin of the case,
ensuring the correct orientation.
5
- 11 5.4 Battery

5.4.1 Battery specifications

Battery specifications
Item
For the battery directive in EU member states, refer to Appendix 2.

Installing the battery

Start
Completed
Figure 5.9 Battery installation procedure
POINT
Engage the battery connector vertically to the connector pin of the case.
Failure to do so may cause a deformation of the connector and damage the
battery case.
Securely push in the battery connector.
Table 5.4 Battery specifications
Manganese dioxide lithium primary battery
3.0V
1800mAh
Actually 5 years (room temperature)
Section 5.4.3 Detecting a battery error and replacing the battery
0.52g
For error logging
Connector
Connector
holder
EtherNet/IP module
Description
Q6BAT
Battery