Setting In-Sensor Data Type - Covidien Nellcor OxiMax N-600x Operator's Manual

Setting In-Sensor Data Type

N-600x Operator's Manual
1. With the monitor in the normal monitoring mode, press the
SETUP softkey.
2. Press the SENSOR softkey.
3. Press the MSG softkey.
4. Press the ADJUST UP or ADJUST DOWN button to toggle the
ENABLE message.
5. Press the EXIT softkey.
The In-Sensor Data Type display enables you to adjust the type of
patient alarm event trend data to be recorded in an O
sensor. O M sensors can be set to record either SpO
XI AX
SpO +BPM.
2
Note: The O M sensor data type can only be set when an
XI AX
O M sensor is not connected to the monitor.
XI AX
1. With the monitor turned on and no cables attached to the
SpO O M sensor port, press the SETUP softkey.
2 XI AX
Using OXIMAX Sensor Event Records
XI
M
AX
or
2
83