Using the Monitor
Setting the Pulse Beep Volume
Setting the Alarm Volume
54
4. Press the ZOOM softkey.
5. Press the SCALE softkey to cycle the trend amplitude scale
display through ±5 points, ±10 points, ±15 points,
±20 points, ±25 points, ±30 points, ±35 points, ±40 points
and ±50 points above and below the newest - rightmost -
trend data point.
Note: You can set the trend amplitude scale to AUTO by pressing
the AUTO softkey. The maximum trend data point is rounded up
to the nearest multiple of 10, shown at the top of the graph
display. The minimum trend data point is rounded down to the
next multiple of 10. 10 is then subtracted from the rounded
down number. This value is located at the bottom of the trend
graph.
With the monitor in the normal monitoring mode, press and hold
the ADJUST UP or ADJUST DOWN button to increase or decrease
the pulse beep volume.
The Alarm Volume display enables you to adjust the volume of
alarm tones.
N-600x Operator's Manual