Using the Data Port
Data Port Setup
108
Use the Data Port Setup display to set the baud rate and the
protocol of the data port on the N-600x.
The Data Port Setup display is accessed by pressing the COMM
softkey on the Setup menu.
1. With the monitor in the normal monitoring mode, press the
SETUP softkey.
2. Press the NEXT softkey twice and then press the COMM
softkey.
3. Press the ADJUST UP or ADJUST DOWN buttons to select the
desired baud rate.
4. Press the SELECT softkey.
5. Press the ADJUST UP or ADJUST DOWN buttons to select the
desired protocol. The available protocols are:
•
ASCII
•
CLINICAL
N-600x Operator's Manual