Oximax Sensor Messages - Covidien Nellcor OxiMax N-600x Operator's Manual

Using the Monitor
O M Sensor Messages
XI AX
66
4. Use the ADJUST UP or ADJUST DOWN buttons to select the
desired language.
5. Press the EXIT softkey.
Note: The selected language displays until the monitor is turned
OFF. The selected language can be set as a default by qualified
service personnel by following the procedures outlined in the
N-600x Service Manual.
O M sensor messages consist of sensor adjust condition
XI AX
messages and sensor adjust messages which, when enabled, are
displayed when the monitor is not able to display saturation.
When O M sensor messages are displayed, it is an indication
XI AX
that the O M sensor is functioning properly, but the site to
XI AX
which the O M sensor applies or the application method is not
XI AX
optimal for calculating %SpO
by action messages. Up to three condition messages may be
displayed on the "POOR SIGNAL CONDITION" display in priority
order, highest on top. The condition display may be dismissed by
using the EXIT softkey. Once closed, the O
screen will not return until a new condition occurs.
If the HELP softkey is pressed from the Condition message display,
the action messages are displayed. Action messages are linked to
the sensor type; action messages will be displayed for the type of
O M sensor connected to the monitor. Up to five action
XI AX
messages may be displayed. Multiple screens may be required to
. Condition messages are followed
2
M sensor message
XI AX
N-600x Operator's Manual