Oximax Sensor Attached - Covidien Nellcor OxiMax N-600x Operator's Manual

Using the Monitor
O M Sensor Attached
XI
AX
46
WARNING: If you do not hear the POST pass tone, do not
use the pulse oximeter.
WARNING: Ensure the speaker is clear of any obstructions.
Failure to do so could result in an inaudible alarm tone.
Note:In addition to serving as the POST pass verification, the
POST pass tone also functions as an audible confirmation that the
speaker is performing properly. If the speaker does not function,
the alarm warning sounds cannot be heard.
WARNING: Do not use any other cables to extend the
length of the DOC-10 Pulse Oximetry Cable. Increasing the
length of the DOC-10 cable will degrade signal quality and
may lead to inaccurate measurements.
When an O M sensor is connected to the monitor, a "SENSOR
XI AX
TYPE: . . ." message is displayed 4 to 6 seconds at the bottom of
the monitor display. The message identifies the type (model) of
O M sensor connected to the monitor. The type is used to
XI AX
determine the action messages in the O
function. This display is the first message displayed when an
O M sensor is connected to the monitor.
XI AX
M sensor message(s)
XI AX
N-600x Operator's Manual