Subaru Legacy 2003 Service Manual page 3955

FLOOR MAT
EXTERIOR/INTERIOR TRIM
26.Floor Mat
A: REMOVAL
1) Remove front seats. <Ref. to SE-7, REMOVAL,
Front Seat.>
2) Remove rear seat cushion. <Ref. to SE-17, RE-
MOVAL, Rear Seat.>
3) Remove console box. <Ref. to EI-34, Console
Box.>
4) Remove front pillar lower trim, side sill rear up-
per cover and center pillar lower trim. <Ref. to EI-
39, REMOVAL, Lower Inner Trim.>
5) Remove clips from floor mat.
NOTE:
When pulling out edge, do not pull mat alone; pull
mat together with edge. Ply off two steel clips on
side sill front cover and one on side sill rear cover
using screwdriver.
6) Remove mat hook.
7) Remove mat from foot rest area.
8) Remove mat from rear heater duct.
9) Roll mat, and then take it out of opened rear
door.
EI-00217
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
• Secure mat firmly with hook and Velcro tape.
• Insert mat edge firmly into the groove of side sill
cover.
EI-48