Subaru Legacy 2003 Service Manual page 3762

C: ADJUSTMENT
NOTE:
Before adjustment, ensure that all adjusting bolts of
stabilizer, upper stopper, and sash are loose and
door glass is raised so that it is in contact with
weatherstrip.
1) Temporarily tighten one adjusting bolt on one
side of rear sash at the midpoint of slotted hole in
the inner panel.
2) Temporarily tighten regulator B-channel in a po-
sition slightly lower than midpoint of slotted hole.
3) Lower door glass 10 to 15 mm (0.39 to 0.59 in)
from fully closed position. While applying outward
pressure of 45±5 N (4.59±0.51 kgf, 10.1±1.1 lb) (F)
to upper edge of glass above midpoint of two outer
stabilizers, press inner stabilizer at 10±5 N
(1.02±0.51 kgf, 2.2±1.1 lb) until it just touches the
glass, then secure it.
( 1 )
A
A = A
( 2 )
(1) Full close
(2) Stabilizer
(3) 10 – 15 mm (0.39 – 0.59 in)
FRONT DOOR GLASS
F
( 3 )
A
( 2 )
GW-00144
4) For adjustment of clearance between front and
rear glasses, loosen nuts (A) and (B), and move
glass sash back and forth until clearance becomes
the value shown.
(1) 38 mm (1.50 in)
5) For adjustment of upper and lower ends of cen-
ter pillar, loosen adjusting nut (A) of B-channel (B).
GW-13
GLASS/WINDOWS/MIRRORS
( A )
( B )
GW-00090
( 1 )
A A
A-A
GW-00145
( B )
( A )
GW-00092