Subaru Legacy 2003 Service Manual page 3981

CRUISE CONTROL SYSTEM
2. Actuator
A: REMOVAL
CAUTION:
• Be careful not to apply excessive load to the
wire cable when adjusting and/or installing;
otherwise, the actuator may be deformed or
damaged.
• Do not bend cable sharply with a radius less
than 100 mm (3.94 in); otherwise, cable may
bend permanently, resulting in poor perfor-
mance.
• When installing cable, be careful not to
sharply bend or pinch the inner cable; other-
wise, the cable may break.
1) Disconnect ground cable from battery.
2) Remove clip bands from cruise control cable.
3) Loosen nut which secures cruise control cable
end to throttle cam and then remove cable from
throttle cam.
4) Remove actuator attaching bolts.
5) Remove actuator while disconnecting connec-
tor.
LHD
ACTUATOR
RHD
B: INSTALLATION
Install in the reverse order of removal.
Tightening torque:
Actuator
Cable end nut
NOTE:
Must be adjusted when cable end outer is fixed in
place, so that gap (A) between throttle cam and le-
ver is 0 — 1 mm (0 — 0.04 in), or inner cable de-
flection (D) is 1 — 8 mm (0.039 — 0.315 in) with
specified range of throttle cable play.
(Must be attached while throttle cam is being pulled
by wire cable.)
Must be coated evenly on cam end inner (B) con-
nection.
CC-00085
Cover (C) must be inserted securely, until tip of ca-
ble touches cover stopper.
CC-00086
CC-4
7.4 N·m (0.75 kgf-m, 5.4 ft-lb)
12 N·m (1,2 kgf-m, 8.7 ft-lb)
(C)
(D)
CC-00125
(B)
(A)
CC-00037