Subaru Legacy 2003 Service Manual page 3823

INSTRUMENTATION/DRIVER INFO
3. Combination Meter Assem-
bly
A: REMOVAL
1) Disconnect ground cable from battery.
2) Set tilt steering at the lowest position.
3) Disconnect each electrical connector to remove
front cover (A) and switch panel (B).
4) Loosen screws (C) to remove center panel (D).
5) Remove meter visor (E).
NOTE:
The following illustration is for LHD model. The lay-
out for RHD model is symmetrically opposite.
( E )
( B )
( C )
( A )
6) Remove screws of combination meter to pull out
the meter toward you.
7) Remove connector in the upper area of combi-
nation meter to remove meter.
CAUTION:
• Be careful not to damage meter or instrument
panel.
COMBINATION METER ASSEMBLY
( D )
: Hook pawl
IDI00027
IDI00028
IDI-14
• Pay particular attention to avoid damaging
the meter glass.