Subaru Legacy 2003 Service Manual page 3942

16.Instrument Panel Assembly
A: REMOVAL
Airbag system wiring harness is routed near the
combination meter.
CAUTION:
• All airbag system wiring harness and con-
nectors are colored yellow. Do not use electri-
cal test equipment on these circuits.
• Be careful not to damage airbag system har-
ness when servicing the instrument panel.
NOTE:
The following location are for LHD model.
The locations for RHD model are symmetrically op-
posite.
1) Disconnect ground cable from battery.
2) Remove lower cover.
(1) Hool pawl
3) Remove lower column cover and disconnect
harness connectors to steering column.
4) Remove steering column assembly (with steer-
ing wheel). <Ref. to PS-28, REMOVAL, Tilt Steer-
ing Column.>
INSTRUMENT PANEL ASSEMBLY
: ( 1 )
EI-00183
EI-00184
5) Remove stopper (A) then remove glove box.
6) Remove side panel of both sides.
: ( 1 )
(1) Hool pawl
7) Remove passenger's airbag module. <Ref. to
AB-13, REMOVAL, Passenger's Airbag Module.>
8) Remove console box. <Ref. to EI-34, REMOV-
AL, Console Box.>
9) Remove front pillar upper trim of both sides.
: ( 1 )
(1) Hool pawl
EI-35
EXTERIOR/INTERIOR TRIM
( A )
EI-00185
EI-00186
EI-00187