Subaru Legacy 2003 Service Manual page 3984

4. Cruise Control Main Switch
A: REMOVAL
1) Disconnect ground cable from battery.
2) Remove screws and clip from instrument panel
lower cover.
3) Remove hook (D) and front cover (A) while dis-
connecting connector.
4) Remove two screws (B) and hook (D), and then
remove center panel (C) while disconnecting con-
nector.
( C )
( B )
( A )
5) Disconnect fifting screws, and slightly pull radio
and switch assembly out from center console.
6) Disconnect electric connectors and antenna-
feeder cord and then disconnect heater controlunit.
7) Remove screw and detach the bracket and then
remove switch panel.
CRUISE CONTROL MAIN SWITCH
( D )
:
CC-00126
CC-00127
CC-00128
CC-7
8) Remove main switch by pushing it outward.
B: INSTALLATION
Install is in the reverse order of removal.
C: INSPECTION
Switch position Terminal No.
OFF (Released)
ON (Pushed)
If NG, replace cruise control main switch.
CRUISE CONTROL SYSTEM
CC-00129
2 1
6 5 4 3
CC-00017
Standard
3 and 5 More than 1 MΩ
Less than 1 Ω
3 and 5