Subaru Legacy 2003 Service Manual page 3588

• Do not drop the airbag modulator parts, subject
them to high temperature over 93°C (199°F), or let
water, oil, or grease get on them; otherwise, the in-
ternal parts may be damaged and reliability greatly
lowered.
• If any damage, opening or rust is found on the
airbag system wire harness, do not attempt to re-
pair using soldering equipment. Be sure to replace
the faulty harness with a new genuine part.
GENERAL DESCRIPTION
• Install the wire harness securely with the speci-
fied clips to avoid interference or tangled up with
other parts.
• Do not allow water or oil to come in contact with
the connector terminals. Do not touch the connec-
tor terminals.
AB-00123
• The airbag module (driver, passenger, and side,
pretensioner) must not be disassembled.
• The airbag module cannot be used again once
inflated.
AB-00124
AB-5
AIRBAG SYSTEM (DIAGNOSTICS)
AB-00125
AB-00126
AB-00127