Subaru Legacy 2003 Service Manual page 3727

Hide thumbs Also See for Legacy 2003:

Table of Contents

WIPER AND WASHER SYSTEMS

10.Rear Wiper Motor

1) Remove rear wiper arm.

2) Remove cap (A), nut (B), and spacer (C) from

rear wiper shaft.

3) Remove rear gate lower trim. <Ref. to EI-44,

REMOVAL, Rear Gate Trim.>

4) Unclip clip of harness and disconnect connector

of wiper motor.

5) Loosen bolts to remove wiper motor assembly

B: INSTALLATION

1) Install in the reverse order of removal.

2) Install rear wiper cushion with the arrow mark

facing up, as shown in the figure.

Tightening torque:

Refer to COMPONENT in General Descrip-

tion. <Ref. to WW-4, REAR WIPER, COM-

PONENT, General Description.>

REAR WIPER MOTOR

C: INSPECTION

1) Connect battery to wiper motor connector and

confirm that wiper motor operates.

2) Connect battery to terminal of connector and re-

move terminal connections with motor rotated, and

stop wiper motor through operation.

3) Connect battery and confirm that motor stops at

automatic stop position after motor operates at low

speed again.

Chapters

Table of Contents