Subaru Legacy 2003 Service Manual page 3601

AIRBAG SYSTEM (DIAGNOSTICS)
3. DRIVER'S AIRBAG (ROLL CONNECTOR
AND AIRBAG MODULE
1) How to disconnect:
(1) Using a flat tip screwdriver, pry the push
lock upward to unlock.
(2) Pull the connector to disconnect from driv-
er's side airbag module assembly.
2) How to connect:
Connect the connector in reverse order of discon-
necting. At this time, be sure to insert the connector
in until connecting sound is heard.
CAUTION:
Be sure to insert the connector in until it locks.
Then pull on it gently to make sure that it is
locked.
4. FRONT SUB-SENSOR, SIDE AIRBAG
SENSOR
1) How to disconnect:
(1) Holding outer part (A), pull it in the direction
of the arrow.
CAUTION:
When pulling, be sure to hold onto the connec-
tor and not the wire.
( A )
AIRBAG CONNECTOR
2) How to connect:
Holding the connector, and push it in carefully until
a connecting sound is heard.
CAUTION:
• Outer (A) moves back, and so do not put your
hand on the outer part.
• Be sure to insert the connector in until it
locks. Then pull on it gently to make sure that it
is locked.
AB-00020
AB-00285
AB-18
( A )
AB-00286