Enabling The Fire Department Override - HySecurity SlideSmart DC 15 Installation And Reference Manual

Enabling the Fire Department Override

Many counties and cities require a Fire Department override system for gate operators. The fire department's
alert system is a separate unit that must be connected to the Smart DC Controller. The FIRE DEPARTMENT
OPEN option must be properly configured through the Installer Menu before the operator will recognize the
alert system.
To enable the Fire Department Override, take the following steps:
1. Connect the contact NO from the alert system or key switch to the following Smart DC Controller
terminals:
EMERG OPEN
+24V
2. Configure the Installer Menu.
At a gate status display, press the MENU button
twice. This accesses the User Menu and the
CLOSE TIMER display appears.
3. Simultaneously, press the OPEN and RESET
buttons to enter the Installer Menu.
Release the buttons and the USAGE CLASS
display appears. It is the first item in the Installer
Menu.
4. Press NEXT until the FIRE DEPARTMENT
OPEN display appears. The factory default
setting is 0.
5. Use the NEXT button to change the number on
the display to 1 and then press SELECT.
6. To exit the Installer Menu, press the MENU
button. The gate status appears in the display
indicating you have returned to Run Mode.
FIRE
Revision D
COM
STOP
OPEN
CLOSE
OPEN
P ARTIAL
EYE
OPEN
EYE
CLOSE
EXIT
LOOP
BLOCK
EXIT
IN OBS
LOOP
OUT OBS
LOOP
CENTER
LOOP
EDGE
EYE
COM
+ 24 V
EMERG
OPEN
SHOW
LEDs
Display and Menu Options
HYSECURITY
GATE CLOSED
OPEN CLOSE STOP MENU RESET
PREV NEXT SELECT
CT 0 (OFF)
CLOSE TIMER
OPEN CLOSE STOP MENU
PREV NEXT SELECT
LL 0 (OFF)
LEARN LIMIT
OPEN CLOSE STOP MENU
PREV NEXT SELECT
FO 1
FIRE DEPT OPEN
OPEN CLOSE STOP MENU
PREV NEXT SELECT
Installer Menu
1. Start at a gate status
display.
2. To access the User
Menu, press MENU
twice.
RESET
3. To access the
Installer Menu,
simultaneously, press
OPEN and RESET
RESET
4. Use NEXT to
navigate to the menu
display. Change the
setting using the
SELECT and NEXT
buttons.
RESET
3-21