Battery Feed Test (Also Called Port Diagnostic Test) (#35) - Avaya G350 Maintenance Manual

Avaya Communication Manager controlled maintenance
AN-LN-PT (Analog Line Port)
Battery Feed Test (also called Port Diagnostic
Test) (#35)
The battery feed chip provides power to the telephone equipment, signaling, rotary dial pulsing,
transmission, and balance. This test checks the signaling and switchhook capabilities of the battery feed
chip by terminating the port, applying battery power, and detecting the resulting current.
Table 37: TEST #35 Battery Feed Test 1 of 3
Error Test
Code Result
ABORT
1000 ABORT
1004 ABORT
1005 ABORT
1018 ABORT
80
Description/Recommendation
Necessary system resources could not be allocated to run this test.
Retry the command at 1-minute intervals no more than 5 times.
If the test continues to abort, escalate the problem.
System resources are unavailable. The port may be busy with a valid call.
This result is also reported for the system's Music-On-Hold port when it is
off-hook, which it usually is.
Enter display port GGGVSpp to determine the station's extension.
Enter status station extension to determine the service state of the
port.
If the port is in use, wait until the port is idle. Retry the command at 1-
minute intervals no more than 5 times.
If the test continues to abort, escalate the problem.
A valid call seized the port during the test and aborted the test.
Use the display port GGGVSpp command to determine the station
extension.
Use the status station extension command to determine the service
state of the port.
If the port is in use, wait until the port is idle before testing. Retry the
command at 1-minute intervals no more than 5 times.
If the test continues to abort, escalate the problem.
This test was aborted due to a configuration problem. The test is not
applicable for this type of analog port. This error can be ignored.
Administration has disabled the test. The default for the Test? field on
the station form is y. Determine why this field has been set to n on this
station (this may be due to the ringing application Test #48, which can be
disturbing to customer or terminal equipment).
To enable the test for a particular station being tested, enter change
station extension .
Change the Test? field on the station form to y.
Maintenance of the Avaya G350 Media Gateway
1 of 3
June 2004