Dial Tone Test (#0) - Avaya G350 Maintenance Manual

Dial Tone Test (#0)

This test attempts to seize a port and checks for the return of a dial tone.
Table 49: Test #0 Dial Tone Test 1 of 3
Error Test
Code Result
ABORT
1000 ABORT
1001 ABORT
1002 ABORT
1004 ABORT
1005 ABORT
Maintenance of the Avaya G350 Media Gateway
June 2004
Avaya Communication Manager controlled maintenance
Description/ Recommendation
Could not allocate system resources to run this test.
1
Retry the command at 1-minute intervals for a maximum of
5 times.
System resources required to run this test are not available. The port
may be busy with a valid call.
1
Use the command display port UUCSSpp to determine the
trunk group/member number of the port. Use the status
trunk command to determine the service state of the port. If
the service state indicates that the port is in use, then the port
is unavailable for certain tests. You must wait until the port is
idle before retesting.
2
Retry the command at 1-minute intervals for a maximum of
5 times.
System resources required to run this test were not available. This
could be due to a failure to seize the port.
1
Retry the command at 1-minute intervals for a maximum of
5 times.
The system could not allocate time slots for the test. The system
may be under heavy traffic conditions or it may have time slots out-
of-service due to TDM-BUS errors.
1
If the system has no TDM-BUS errors and is not handling
heavy traffic, retry the command at 1-minute intervals for a
maximum of 5 times.
The port was seized by a user for a valid call.
1
Use the display port UUCSSpp command to determine the
trunk group/member number of the port. Use the status
trunk command to determine the service state of the port. If
the service state indicates that the port is in use, then the port
is unavailable for certain tests. You must wait until the port is
idle before retesting.
2
If the port status is idle, retry the command at 1-minute
intervals for a maximum of 5 times.
Trunk has been administered as incoming-only; dial tone can only
be obtained on outgoing trunks. This is a normal condition.
CO-TRK (Analog CO Trunk)
1 of 3
99