Saki Sanity Test (#53) - Avaya G350 Maintenance Manual

Avaya Communication Manager controlled maintenance
MG-DS1 (DS1 Interface Media Module)

SAKI Sanity Test (#53)

CAUTION:
This test resets the Media Module. The test is highly destructive and can only be initiated
by a system technician-demanded reset board GGGVS command.
Table 108: Test #53 SAKI Sanity Test 1 of 2
Error Test
Code Result
None ABORT
1005 ABORT
1015 ABORT
2100 ABORT
1 FAIL
2 FAIL
186
Description/ Recommendation
System resources required for this test are not available.
Retry the reset board command at 1-minute intervals a maximum of 5
times.
Wrong Media Module configuration to run this test. This error applies only
to DS1 Interface Media Modules. It means the DS1 Interface Media
Module is providing timing for the system, and therefore, it cannot be reset
without major system disruptions.
If the Media Module needs to be reset, then set synchronization to another
DS1 Interface Media Module or to the Tone-Clock Media Module and try
again.
Port is not out-of-service.
Busyout the Media Module.
Execute the reset board command again.
System resources required for this test are not available.
Retry the reset board command at 1-minute intervals a maximum of 5
times.
The Media Module failed to reset.
The Media Module failed to restart.
Execute the reset board command again.
If the problem persists, replace the Media Module.
Maintenance of the Avaya G350 Media Gateway
1 of 2
June 2004