Diod-Trk (Diod Trunk) - Avaya G350 Maintenance Manual

Avaya Communication Manager controlled maintenance

DIOD-TRK (DIOD Trunk)

Table 68: TEST#17 Station (Digital) Audits Test 2 of 2
Error Test
Code Result
FAIL
PASS
Any NO
BOARD
DIOD-TRK (DIOD Trunk)
Table 69: DIOD-TRK (DIOD Trunk)
MO Name (in
Alarm Log)
DIOD-TRK
DIOD-TRK
DIOD-TRK
Note: You must consult local records for the location and designation of the equipment rack
where the G350 is mounted.
A MAJOR alarm on a trunk indicates that alarms on these trunks are not downgraded by the set
**
options command and that at least 75 percent of the trunks in this trunk group are alarmed.
Many trunk problems are caused by incorrect settings of parameters on the trunk group administration
form. Settings must be compatible with the local environment and with parameter settings on the far-end.
Refer to the Administration Manual for information on how to administer trunks. The Application Notes
section of that book shows the correct settings for administrable timers and other parameters on a
country-by-country basis.
130
Description/ Recommendation
Internal system error
Retry the command at 1-minute intervals a maximum of 5 times.
Station Audits passed. This Digital Port Media Module is functioning
properly.
If complaints persist, investigate by using other port tests, and by
examining the station, wiring, and connections.
The test could not relate the internal ID to the port.
Check to ensure that the board translations are correct. Translate the board,
if necessary.
Use the busyout board command.
Use the reset board command.
Use the release busy board command.
Use the test board command. This should re-establish the linkage
between the internal ID and the port.
If the problem persists, replace the circuit pack.
Alarm Level Initial Command to Run*
MAJOR** test port GGGvSpp l
MINOR test port GGGvSpp l
WARNING test port GGGvSpp l
Maintenance of the Avaya G350 Media Gateway
2 of 2
Full Name of MO
DIOD Trunk
DIOD Trunk
DIOD Trunk
June 2004