Port Audit Update Test (#36) - Avaya G350 Maintenance Manual

Avaya Communication Manager controlled maintenance
CO-TRK (Analog CO Trunk)

Port Audit Update Test (#36)

This test will send updates of the CO port translation for all ports on the Media Module which have been
translated. The update is non-disruptive and guards against possible corruption of translation data
contained on the Media Module. No response message is expected from the Media Module once it
receives translation updates. The port translation data includes: ground or loop start trunk, tone or rotary
dialing trunk, rotary dialing inter-digit timing, network balance R/RC, and disconnect timing.
Table 51: TEST #36 Port Audit Update Test 1 of 2
Error Test
Code Result
ABORT
1006 ABORT
2100 ABORT
FAIL
PASS
104
Description/ Recommendation
Could not allocate the necessary system resources to run this test.
Retry the command at 1-minute intervals for a maximum of 5 times.
The port has been placed out of service, perhaps by craft busyout.
Use the display port GGGVSpp command to determine the trunk
group/member number of the port. Use the status trunk command to
determine the service state of the port. If the service state indicates that the
port is in use, wait until the port is idle before testing.
If the port status is idle, retry the command at 1-minute intervals for a
maximum of 5 times.
System resources required to run this test were not available.
If the port status is idle, retry the command at 1-minute intervals for a
maximum of 5 times.
Internal system error
Retry the command at 1-minute intervals for a maximum of 5 times.
This test passed. Translation information was successfully updated on the
Media Module. User-reported troubles on this port should be investigated
by using other port tests and by examining trunk or external wiring. If the
trunk is busied out, the test will not run, but will return PASS. To verify
that the trunk is in-service:
Enter status trunk to verify that the trunk is in-service. If the trunk is in-
service, no further action is necessary. If the trunk is out-of-service,
continue to Step 2.
Enter release trunk command to put trunk back into in-service.
Retry the test command.
Maintenance of the Avaya G350 Media Gateway
1 of 2
June 2004